Improving performance through defect detection and edge break measurement

Especially for critical aircraft engine parts such as turbine disks, it is safety-relevant that the break edges lie within defined tolerances. To prevent high stress and damaged parts, Alicona optical 3D metrology is used to ensure that the break edge geometry corresponds to specifications. 

BENEFITS ALICONE 

Measurement of minimum radius to make sure it is not too small and analysis whether the machined profile is within the tolerance zone

Measurements can be performed directly on the component using the robot-based measurement solutions Alicona Cobots

Measurement procedure and optical scanning sequences are fully automated so that user influence is reduced

Non-destructive measures in (MRO) 

3D measurements allow detecting and quantifying defects in surfaces and edges. of all kinds of components. 

BENEFITS ALICONA  

Measurements of 3D areas and visualization of defects and marks, including length, depth, volume and height steps. The Coicots of Alicona allow measurements to be made not only on the replicated materials, but also directly on the parts. To measure the components, the Cobots can be manually guided to the required measuring position.

Need more information?